It was now time to install the Maximus-3 Hook Anchor & our Rubicon Express Billet Aluminum Hawse Fairlead. Because our winch installation is centered, we will want our Hawse Fairlead to be centered also. The factory cutout on the Mopar bumper is off-centered so we will have to do a little cutting to correct the opening and make it work with a centered winch.
Remove Plastic Trim Covering
Removing the factory plastic trim covering is easy however you need to cut off the 4 Retaining Clips using a pair of metal shears. Attempting to remove the Retaining Clips without cutting them will probably result in damaging the Plastic Trim covering so just go right for cutting the clips and save the Rubicon trim covering for some neat wall art.
Prep for Centered Hawse Fairlead
With the Plastic Trim Covering removed, we now see the offset factory winch cable opening. Overlaying the centered Hook Anchor we can see the area of material that will have to be removed to allow for a centered winch installation.
Mark, Punch and Drill
Using the center of the factory holes as a guide, mark a center line across the horizontal factory fairlead holes (left to right). Then mark a center line vertically through the two outer holes on the passenger side. From the vertical line measure over towards the driver side 48mm (1 7/8″) and center punch that point on the horizontal line. Drill an 1/8″ pilot hole.
Drill, Cut, Debur & Touchup
Using the pilot hole, drill a 44mm (1 3/4″) hole using a Hole Saw. Then using our angle grinder we connected the 1 3/4″ hole with the factory fairlead hole, deburred and finally touched up the bare metal with black spray paint.
Install Maximus-3 Hook Anchor
Using a 7/32″ Alan Wrench on the front side and a 9/16″ socket on the bolt we installed the Hook Anchor plate using the provided hardware.
Install Hawse Fairlead
Then we installed our black Rubicon Express Billet Aluminum Hawse Fairlead. We dig the engraved RUBICON right on the Fairlead.
The next section will reinstall the Bumper, Install the Maximus-3 Auxiliary Light Brackets and the Maximus-3 Classic Hoop Bar and Reinforcement Brackets.
In this Article Series
For more information on Maximus-3 Products: